One extreme and frustating example was routing just one trace. I would switch layers and the program would hang for way too long. Placing vias and using having the "push" command enabled to push traces or other vias out of the way was supper laggy. To the point that scrolling left or right was lagging badly to when it finally caught up, I was way left or right to where I wanted to be. Near the end when I had 90% of the board done, doing interactive routing really slowed my laptop down. ![]() Was doing a job that involved my largest layout to date. RF, PLC, CAD, HW Startups, Robotics, Microcomputing, DIY Audio, DIY Gear, DIY, Mindstorms, ASM, EE Books, Product Design, LabVIEW, Breadboard, RTLSDR, Manufacturing, Electronic Circuits. AskElectronics, Electronics, ECE, RPi, NiceChips, DevKit, Arduino, micro:bit, Nucleo, STM32F4, MSP430, PSoC, ARM, Amp Hour, FPGA, DSP,.How to solder: SMD Resistors, SMD ICs, SMD QFP IC, SMD Drag Solder, SMD Tips, 1980 Soldering Videos.Gerbv, GerberLogix, DFM Now, ViewMate, ZofzPCB, GC-Prevue, RefGerbView. Pro ($$$$): Altium, Allegro, OrCAD, PADS, Xpedition. ![]() WIKI / FAQ / PCB Review Tips / 3D models / SPICE models / Book ListĮagle, Fritzing, KiCad, LibrePCB.Links within /r/PrintedCircuitBoard subreddit: Subreddit to discuss tips for Electronic Schematic Capture / PCB Layout / 3D Part Models / Board Assembly, and Schematic & PCB Reviews.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |